Hookups And Settings; Hookingupthe Recorder; Step1: Unpacking; Step2: Connecting The Antennacable - Sony RDR-GX315 Operating Instructions Manual

HookingUpthe Recorder
Follow sleps 1 Io 7 to book up and adjust tile
settings of"Ihe recorder.
• Plug cords securely to prevent unwanted noise.
• See the instruction s supplied wilb the components to be
connected.
• You cannot connect this recorder to a TV that does not
have a vkleo input jack.
• Be sure to disconnect the power cord of each
component before connecting.
Step1: Unpacking
Check that you have the lollowiug items:
• Audio/video cord
(phono plug x 3 _ phono plug × 3) (1)
• Anteuna cable (1)
• Remote commander (remote) (I)
• Size AA (R6) batteries (2)
Step2: Connecting the
AntennaCable
Select one of the tMlowing antenna hookups. Do
not connect the power cord until you reach
"Connecting the Power Cord" on page 19.
If you have Hookup
Cable box or satellite receiver with a A (page 131
video/audiu output
Cable box with an antenna output B (page 14)
only
Cable without cable box, or antenna C (page 14)
only (no cable TV)
Note to CATVsysteminstaller (in USA)
This reminder is provided to call the CATV
system installer's attention to Article 82()=41)of
the NEC that provides guidelines for proper
grounding and, in particular, specifies that the
cable ground shall be connected to the grounding
system of the building, as close to the point of
cable entry as practical.
I I_mF-Igl
• If your antenna is a fiat cable (300-ollm twin lead
cable), use
all
external antenna connector (not
supplied) to connect the antenna to tile recorder.
• If you llave separate cahles for VHF and UHF
antennas, use a UHF/VHF hand mixer (not supplied) to
connect the antenna to tile recorder.
12