Shelves And Bins - GE CAFE CZS22M Owner's Manual And Installation Instructions

Shelves and Bins

Not all features are on all models.
Refrigerator Door Bins and Freezer Door Tilt-Out Bins
Large Bins
bins are adjustable.
To remove: Lift the front of the bin straight up, then lift
up and out.
To replace or relocate: Engage the back side of the bin
in the molded supports of the door. Then push down on
the front of the bin. Bin will lock in place.
Small Bins
To remove: Lift the front of the bin straight up then out.
To replace: Position the bin above the rectangular
molded supports on the door. Then slide the bin down
onto the support to lock it in place.
The snugger helps prevent tipping, spilling or sliding of
small items stored on the door shelf. Place a finger on
either side of the snugger near the rear and move it back
and forth to fit your needs.
NOTE: Be careful when placing items in the top bin.
Make sure that items do not block or fall into the ice
chute.
Slide-Out Spillproof Shelf
The slide-out spillproof shelf
allows you to reach items
stored behind others. The
special edges are designed
to help prevent spills from
dripping to lower shelves.
To remove: Slide the shelf out
until it reaches the stop, then
press down on the tab and
slide the shelf straight out.
QuickSpace™ Shelf
This shelf splits in half and slides under itself for storage
of tall items on the shelf below.
This shelf can be removed and
replaced or relocated just like
Slide-Out Spillproof Shelves.
On some models, this shelf
can not be used in the lowest
position.
49-1000209 Rev. 0
Press tab and pull shelf
forward to remove
(on some models)
To replace or relocate: Line the shelf up with the
supports and slide it into place. The shelf can be
repositioned when the door is at 90° or more. To
reposition the shelf, slide
the shelf past the stops
and angle downward. Slide
shelf down to the desired
position, line up with the
supports and slide into
place.
Make sure you push the shelves all the way back in
before you close the door.
Slide-Out Freezer Shelves
To remove, slide the shelf back to the stop position, lift
the left side and slide out from the ribs.
To install the shelf, reverse
these steps. Make sure to push
the shelves all the way back in
before closing the door.
NOTE FOR DISPENSER
MODELS: In order to take full
advantage of the tilt-out ice bin
(on some models), only store
items on the shelf below the ice
bin that are no taller than the
lowest point on the bin.
Door bins
Ice Chute
7