Table of Contents
Advertisement
Notes on playing the DTS sound tracks on a CD
• Do not play the DTS sound tracks without connecting the
player to an audio component having a built-in DTS decoder.
The player output the DTS signal via the DIGITAL OUT
OPTICAL and COAXIAL connectors even if "DTS" in "AUDIO
SETUP" is set to "OFF" in the setup display, affecting your ears
or causing the speakers to be damaged.
• Set the sounds to "STEREO" when you play the DTS sound
tracks on a CD. (See "Changing the Sounds" on page 30.) If
you set the sounds to "1/L" or "2/R", no sounds will come out
from the DIGITAL OUT OPTICAL and COAXIAL connectors.
Notes on playing the DTS sound tracks on a DVD
• No sounds will come out from the LINE OUT (AUDIO)
connectors.
• If the player is connected to an audio component lacking a
built-in DTS decoder, do not set "DTS" in "DIGITAL OUT" to
"ON" in the setup display. Otherwise, when you play the DTS
sound track, a loud noise will come out from the speakers,
affecting your ears or causing the speakers to be damaged.
• When you set "DTS" in "AUDIO SETUP" to "OFF", no sound
will come out from the DIGITAL OUT OPTICAL and
COAXIAL connectors even if you play DTS sound tracks on
DVDs.
Controlling the TV or the
AV Receiver (Amplifier)
with the Supplied Remote
Z
If you adjust the remote signal, you can control your TV
with the supplied remote. Default setting is to control
Sony TVs with the g mark.
When you connect the player to a Sony AV receiver
(amplifier), you can also set the input of the receiver
(amplifier) to this player with the supplied remote.
TV/
DVD•AV CENTER
switch
1
4
Number buttons
7
Controlling TVs with the remote
1
Slide the TV/DVD•AV CENTER switch to TV.
2
Hold down 1/u (POWER), and enter your TV's
manufacturer's code (see the table) using the
number buttons. Then release 1/u (POWER).
Code numbers of controllable TVs
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
TV.
Notes
• If you enter a new code number, the code number previously
entered will be erased.
• When you replace the batteries of the remote commander, the
code number may reset to 01 (Sony). Reset the appropriate code
number.
1/u (POWER)
2
3
5
6
8
9
0
51
Hide quick links:
Advertisement
Table of Contents
