Registry - insys icom i-modul 144/56k Designer's Manual

i-modul Modem 144/56k
9 S Registry
S registers may be read and written using the ATS<n> command. (Refer also
to the AT Command Reference). Certain S registers may only be read; others
only allow to enter a particular range of values.
If the range of values is exceeded, the modem will report OK, although the
value was not accepted. We therefore recommend to immediately check
modifications by reading (ATS<n>?).
Note:
* These registries are stored in the user defaults with AT&W0 or AT&W1.
** The defaults can differ depending on the configured country
code.
S Registry
47