Controlling Your TV or AV
Amplifier (Receiver) With
the Supplied Remote
By adjusting the remote signal, you can
control your TV with the supplied remote.
If you connect the player to an AV amplifier
(receiver), you can control the volume with
the supplied remote.
• Depending on the unit being connected, you may
not be able to control your TV using some of the
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the remote's batteries, the code
number you have set may be reset to the default
setting. Set the appropriate code number again.
Controlling TVs with the remote
Slide the TV/DVD switch to TV.
Hold down [/1, and enter the
manufacturer's code for your TV using
the number buttons (see "Code
numbers of controllable TVs" below).
When the TV/DVD switch is set to TV,
the remote performs the following:
Code numbers of controllable TVs
If more than one code number is listed, try
entering them one at a time until you find the
one that works with your TV.
Turns the TV on or off
Adjusts the volume of the TV
Selects the channel of the TV
Switches to or from the wide
mode of a Sony wide TV
Switches the TV's input
source between the TV and
other input sources
The button works even if the
TV/DVD switch is set to