Troubleshooting - Sony PVP-MSH Operating Instructions Manual

Troubleshooting

If you run into any problem using this unit, use the following table to
troubleshoot the problem. If the problem persists, disconnect the power
source and contact your Sony dealer or local authorized Sony service
facility.
Symptom
Print paper cannnot be
drawn in the paper feeder.
Images do not become still
images even you press
PRINT.
26-US
Cause and/or Corrective Actions
• The printer is not attached correctly.
t Attach it correctly.
• The battery power is low.
t Use the battery pack charged fully.
• The print cartridge is not inserted.
t Insert the print cartridge.
• You have inserted print paper into the
paper feeder right after you turned the
power source on or right after you
opened the printer cover.
t Remove the print paper once.
Make sure that the PAPER lamp is
flashing slowly, and then insert print
paper into the paper feeder.
• The POWER switch on your camcorder is
not set to MEMORY.
t Set it to MEMORY.
• The print paper is not inserted properly.
t Press the print paper into the paper
feeder for about two seconds after the
beep sounds.
• Printing images continuously makes the
inside of the printer heat up. When this
happens, you may not be able to insert
print paper.
t Leave this unit until it cools down,
then insert print paper into the paper
feeder again.
• SLIDE SHOW is executed on your
camcorder.
t Cancel SLIDE SHOW or inset the
print paper again after SLIDE SHOW
has completed.
• Print paper or the print cartridge is not
inserted.
t Insert the print paper or the print
cartridge.