Compensation Of Left Parallel Section Of A Buttonhole; Compensation Of Cutting Space, Left; Setting The Needle Throwing Width Of The Right Bottom Of Eyelet - JUKI MEB-3810N Series Instruction Manual

7-15. Compensation of left parallel section of a buttonhole

–
+

7-16. Compensation of cutting space, left

+

7-17. Setting the needle throwing width of the right bottom of eyelet

❼
❻
❼
❻
Clearance
–
❼
❻
width
− 57 −
Length from the bottom of eyelet to the left side of
parallel section can be adjusted.
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key
Setting can be performed －0.6 to 0.6 mm in the in-
crements of 0.1 mm.
The clearance where the knife drops in the left side of
the parallel section can be compensated.
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key
Compensation is carried out in such a way as to add
this set value to the value of Data No.6 "Cutting space
setting".
If the setting is "＋", the clearance becomes larger than
that on the right side, and if it is "－", the clearance
becomes smaller.
The cutting space, left can be set in increments of 0.1
mm within the range of "–1.2 ≤ cutting space + cutting
space left, compensation ≤ 1.2 mm".
Needle throwing width of the right side of the bottom
of eyelet can be set.
Feed base is actuated with the needle throwing to
change the sewing width.
Set the knife number by means of –/BACKWARD key
❻ or +/FORWARD key
It can be set in increments of 0.1 mm within the range
of 2.5 mm ± 1.0 mm.
❼.
❼.
❼.