Whirlpool WRF954CIHV Service Manual page 48

COMPONENT ACCESS
Accessing Refrigerator Compartment Components (Continued)
Crisper Frame Assembly
1. Complete the steps 1-5
instructions.
2. Fully extend the platter shelf, depress and release the two
tabs on the underside of the pantry shelf. Remove the shelf
from the cabinet.
Opening on Underside of
Crisper Assembly
3. Lift the back of the crisper glass from the underside,slide back
until the two front edges are released. Remove the crisper
glass.
4. Twist counter-clockwise and remove the water filter.
5. Lift and slide the crisper assembly forward until the rear
center of the assembly clears the base of the air tower cover.
Continue lifting and remove the crisper frame assembly.
Temperature Controlled Drawer LED Light and
Thermistor
The LED Light and thermistor for the temperature controlled
drawer share the same wiring harness. They are serviced as a
pair.
1. Complete the steps 1-5
instructions.
2. Flip over the Crisper Frame Assembly with the front facing
you.
3. Remove the three Philip screws attaching the left rail to the
bottom of the drawer frame.
4. Remove the three Philip screws attaching the right rail to the
top of the drawer frame.
5. Press the tab on the right side of the water filter fascia and
release.
6. Release the two plastic clips holding the right rail to the top
of the drawer frame, and lift off the bottom of the drawer
frame.
7. Remove the six (6) Philip screws attaching the LED Light to
the drawer frame.
8. Remove the four (4) Philip screws attaching the wire channel
to the drawer frame.
French-Door Bottom Mount Refrigerator
n
3-6
from "Refrigerator Door" removal
from "Crisper Frame Assembly"
9. Unclip the Thermistor and remove the LED Light, thermistor
and associated wiring.
NOTE: To prevent pinching of the wires,ensure the wiring is
run through the plastic channel in the underside of the
drawer frame during installation.
Water Filter Bracket and Water Filter Housing
1. Complete the steps 1-5
instructions.
2. Remove the two 1/4" screws at the front of the water filter
bracket base.
3. Release the water inlet and outlet lines from the water filter
bracket, and remove the bracket.
4. To remove the water filter housing from the bracket, release
the two plastic tabs at the front top and bottom of the
housing, and slide out from the back.
5. When reinstalling the water filter bracket, ensure the under
filter foam insulation is in place, and the two plastic feet on
the rear of the bracket are inserted into the plastic recess in
the base of the refrigerator liner.
Wire Channel
from "Crisper Frame Assembly"
Plastic Feet
Foam Insulation