Accessing The Refrigerator Door Parts - Whirlpool WRF954CIHV Service Manual

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
Refrigerator Doors
1. Using a Philips screwdriver, remove the hinge cover from the
top hinge.
2. (Left Door Only) Disconnect the water dispenser tubing
located on top of the door hinge. Firmly pull up on the clasp.
Then,pull the tubing out of the fitting.
NOTE: The water dispenser tubing remains attached to the
left-hand refrigerator door.
3. (Left Door Only) Disconnect the wiring connectors located on
the top of the door hinge.
NOTE: Do not remove the green ground wire. It should
remain attached to the door hinge.
4. Use a TORX
T25 screwdriver to remove the three screws
®
from the top hinge.
5. Open the door to 90° to the front of the cabinet and lift the
door from the bottom hinge pin.

Accessing the Refrigerator Door Parts

Door Mullion
6. Place mullion in the door closed position and remove the
1/4" screw at the center of the mullion.
7. Slide the mullion up to remove from the tabs at the top and
bottom hinges.
8. Disconnect the wiring connector for the mullion heater and
remove the mullion.
NOTE: When installing the mullion,ensure the wiring
connector is placed behind the plastic retaining clip.
lcemaker Assembly
1. Remove the ice bucket.
2. Depress the plastic tabs on the bottom left and right sides of
the lcemaker and slide out.
3. Disconnect the wiring connector and remove the lcemaker.
Door Ice Maker Fill Tube and Heater
4. Disconnect the ice maker fill tube (blue) clasp under the left
hinge cap.
5. Use pliers to pull fill tube and heater from top of the ice
maker housing.
NOTE: Attach a string to the clasp end of the fill-tube to aid in
fishing through the new fill tube.
Ice Dispenser Motor
1. Remove the ice bucket.
2. Remove the four Philip screws retaining the ice chute plate.
3. Remove the four 1/4" screws from the ice dispenser motor
and lift out.
4. Disconnect the wiring connector and remove the ice
dispenser motor.
French-Door Bottom Mount Refrigerator
COMPONENT ACCESS
n
3-3