Table of Contents
Advertisement
Rear Panel
ANTENNA a block
1 ANTENNA a / ANT IN/DC OUT (9V/OFF/12V)
connector
Through a single coaxial cable, it accepts the signal
from the UHF antenna while supplying power to the
antenna to drive the antenna booster. The supply
power can be set to 9V, OFF or 12V with the
ANTENNA a DC OUT switch on the front panel.
2 ANTENNA a / OUTPUT (TV-CH) 59 to 61
connectors
Connect to the ANTENNA a IN connectors of other
antenna dividers or tuners.
Note
This unit works only in the band between 774 MHz
and 798 MHz (TV channels 59, 60, and 61).
The connectors with the markings 62, 63 and 64 have
no functions.
AC power block
3 AC IN connector
Connect to an AC power source with the supplied AC
power cord.
DC OUT
59
60
61
62
63
(9V/OFF/12V)
OUTPUT (TV-CH)
ANT IN
ANTENNA
b
5 ANTENNA b / OUTPUT (TV-CH) 59 to 61
connectors
4 ANTENNA b / ANT IN/DC OUT
(9V/OFF/12V) connector
1 ANTENNA a / ANT IN/DC OUT
(9V/OFF/12V) connector
2 ANTENNA a / OUTPUT (TV-CH) 59 to 61
connectors
DC OUT
64
59
60
61
62
(9V/OFF/12V)
OUTPUT (TV-CH)
ANT IN
ANTENNA
a
ANTENNA b block
4 ANTENNA b / ANT IN/DC OUT (9V/OFF/12V)
connector
Through a single coaxial cable, it accepts the signal
from the UHF antenna while supplying power to the
antenna to drive the antenna booster. The supply
power can be set to 9V, OFF or 12V with the
ANTENNA b DC OUT switch on the front panel.
5 ANTENNA b / OUTPUT (TV-CH) 59 to 61
connectors
Connect to the ANTENNA b IN connectors of other
antenna dividers or tuners.
Note
This unit works only in the band between 774 MHz
and 798 MHz (TV channels 59, 60, and 61).
The connectors with the markings 62, 63 and 64 have
no functions.
3 AC IN connector
⁄ AC IN
63
64
AC power cord
(supplied)
to an AC power source
7
Advertisement
Table of Contents
