Rear Panel - Sony WD-850 Operating Instructions Manual

Rear panel

5 ANTENNA B IN/ DC OUT 1 and 2 connectors
ANTENNA A block
a ANTENNA A IN / DC OUT 1 and 2 (antenna A
input/DC power output 1 and 2) connectors
When connected by coaxial cable, the signal is input from
the AN-820A UHF antenna while power is supplied to the
antenna's booster amplifier. The power supply can be set
to 9V or OFF using the ANTENNA A DC OUT switch on
the front panel. Depending on the required range of the
wireless microphone, up to two antennas can be connected.
b ANTENNA A CASCADE connector
During use of two dividers at the same time, connect this
connector to the ANTENNA A IN/DC OUT connector 1
or 2 on the second divider.
c ANTENNA A OUT 1 to 4 (antenna A output 1 to 4)
connectors
Connect from ANTENNA A OUT connector on the unit to
the ANTENNA A IN connector on the tuner.
AC power block
d AC IN connector
Connect to an AC power source with the supplied AC
power cord.
8
Location and function of parts
1 ANTENNA A IN/ DC OUT 1 and 2 connectors
7 ANTENNA B OUT 1 to 4 connectors
6 ANTENNA B CASCADE connector
2 ANTENNA A CASCADE connector
3 ANTENNA A OUT 1 to 4 connectors
4 AC IN connector
ANTENNA B block
e ANTENNA B IN / DC OUT 1 and 2 (antenna B
input/DC power output 1 and 2) connectors
When connected by coaxial cable, the signal is input from
the AN-820A UHF antenna while power is supplied to the
antenna's booster amplifier. The power supply can be set
to 9V or OFF using the ANTENNA B DC OUT switch on
the front panel. Depending on the required range of the
wireless microphone, up to two antennas can be connected.
f ANTENNA B CASCADE connector
During use of two dividers at the same time, connect this
connector to the ANTENNA B IN/DC OUT connector 1 or
2 on the second divider.
g ANTENNA B OUT 1 to 4 (antenna B output 1 to 4)
connectors
Connect from ANTENNA B OUT connector on the unit to
the ANTENNA B IN connector on the tuner.
AC power cord (supplied)
to an AC power source