Philio TSM01 Manual page 6

Light
4 99
0~100
Threshold
Operation
5 0
0~127
Mode
6 Multi-Sensor 4
0~127 Multi-Sensor function switch. Using bit to
Function
Switch
turn on the light. For dimmer equipment
1 to 100 means the light strength.
Setting the illumination threshold to turn
on the light. When the event triggered
and the environment illumination lower
then the threshold, the device will turn
on the light.
0 means turn off illumination detected
function. And never turn on the light.
1 means darkest.
99 means brightest.
100 means turn off illumination detected
function. And always turn on the light.
Notice: In none test mode, only the
value in 1 to 99 will enable the
illumination detected function and
update the illumination value.
Bit0: Reversed.
Bit1: Reversed.
Bit2: Disable the door/window function.
Bit3: Setting the temperature scale.
0: Fahrenheit , 1: Celsius
Bit4: Disable illumination report after
event triggered.
Bit5: Disable temperature report after
event triggered.
control.
Bit0: Disable magnetic integrate
illumination.
Bit1: Reserved, always 1.
Bit2: Reserved, always 1.
Bit3: Reserved.
Bit4: Disable delay 5 seconds to turn off
Auto Report
10 12
Battery Time
Auto Report
11 Door/Window 12
State Time
Auto Report
12 Illumination 12
Time
Auto Report
13 Temperature 12
Time
6
the light, when door/window closed.
Bit5: Disable auto turn off the light, after
door/window opened to turn on the
light.
Bit6:Enable temperature monitoring.
When this bit enable, the temperature
changed 3 degree Fahrenheit, it will
report.
And also the temperature over 140
degree Fahrenheit, it will report every 64
seconds.
The interval time for auto report the
battery level. 30 minutes per tick and
1~127
minimum time is 30 minutes, default tick
is 12 (6 hours).
The interval time for auto report the
door/window state. 30 minutes per tick
1~127
and minimum time is 30 minutes, default
tick is 12 (6 hours).
The interval time for auto report the
illumination. 30 minutes per tick and
1~127
minimum time is 30 minutes, default tick
is 12 (6 hours).
The interval time for auto report the
temperature. 30 minutes per tick and
1~127
minimum time is 30 minutes, default tick
is 12 (6 hours).