Holster - Panasonic Toughbook FZ-T1 Series Operating Instructions Manual

Supplementary items

Holster

Handling and maintenance
•
The holster is designed for carrying the specified unit; it is not designed to protect the unit from drops,
shock, vibration, water, etc.
•
Wrap the belt around the waist.
•
Do not leave the holster in areas with high temperatures, such as near a fire or heater, in areas exposed
to direct sunlight, such as inside a vehicle, or in areas with high humidity, such as bathing areas.
•
Store the holster in a cool, dry place with sufficient air circulation, free from dust and chemicals.
•
Keep the belt out of reach of children.
•
For typical cleaning, wipe the holster with a soft, dry cloth.
–
If the holster becomes dirty, wet a soft cloth with water and wring it thoroughly before wiping the
holster.
–
Do not clean the holster with benzene, thinner, alcohol, household cleansers, etc., as these may harm
the holster.
•
If the holster becomes wet from cleaning or from typical use, dry it with a dry cloth and allow it to air dry.
Attaching
1.
Open the snaps (A) on rear of the holster and lift up the rear flap (B).
2.
Rest the included belt against the rear of the holster as shown in the illustration on the left.
3.
Lower the rear flap and close the snaps.
•
Make sure the belt and the back of the holster (C) are fastened to each other.
4.
Attach the included belt to the wearer and adjust the belt length so that it fits snugly.
•
A pen holder (D) is also attached.
5.
Insert the unit as shown in the right illustration above, and close the front flap (E).
•
You can store a spare battery in the pocket (F).
•
Firmly fasten the front flap and pocket.
•
You can also fold back the front flap twice at the seam lines (the dotted lines in the upper-right
illustration) and insert it into the storage area (G).
44 Operating Instructions - Reference Manual