Installing and removing the battery
•
If the cover latch is closed, open it (page 12).
Installing the battery
1.
Insert the tabs at the battery's terminal side into the notches of the unit (
into place (
).
2.
Press down firmly on the outside edges of the battery to seal it closed.
3.
Close the cover latch (
•
If the gap above the latch or the red area inside the switch is visible, the latch is not properly closed
or locked.
IMPORTANT
•
Observe the following to ensure the waterproof and dustproof performance of the unit.
–
When installing the battery, make sure there is no debris lodged in the gasket of the battery and
the unit.
–
Make sure the gasket of the unit is not damaged, deformed, or peeled off.
) and lock it (
) by sliding the switch (circled in the illustration) toward
), and then lower the battery
Operating Instructions - Reference Manual
Getting started
.
11