Supplementary Items; Protective Film - Panasonic Toughbook FZ-T1 Series Operating Instructions Manual

Supplementary items

Supplementary items

Protective Film

How to apply the Protective Film
Apply the Film so that the word TOP or UP on the peel-off sheet can be read from the top.
* The word TOP is used in the illustrations.
Note
•
Do not bend the Protective Film. Creases may prevent the Film from being applied smoothly to the
screen, and may make the screen difficult to see.
1.
Use a soft, dry cloth to remove dirt, dust, fingerprints, etc., from the screen surface.
•
If the Protective Film is applied while foreign matter remains on the screen surface, air bubbles or
abrasions may result.
2.
Firmly apply the entire adhesive part of a tab to the top corner of the peel-off sheet on the adhesive
side as positioned in the figure. Pull the tab to peel back about 3 cm of the sheet from the Protective
Film.
•
At this time, do not touch the adhesive side, or leave the Film lying around, as dust or other foreign
matter might settle on it.
•
You cannot reuse tabs.
3.
Align the adhesive side of the Protective Film with the top edge of the screen, and carefully attach the
Film to the screen while peeling off the peel-off sheet.
•
If the Film is positioned incorrectly, or if large air bubbles are visible, peel off the Film and re-apply.
If dust or other foreign matter should settle on the adhesive side of the Protective Film, remove it
with cellophane tape.
42 Operating Instructions - Reference Manual
Adhesive side of the Protective Film
Peel-off sheet
Tab (Apply so that about
1 mm sticks out)