Installing The Sony Rx100 Iv/V Camera - Hugyfot Vision Sony RX100 IV/V User Manual

Table of Contents

Advertisement

Step 2: installing the camera power bank
-
Place camera battery pack in the tray, confirming that the "On/Off" switch
aligns with bottom red push button (1);
-
Connect USB battery pack to camera USB power using the 2.1A outlet (2);
-
Seat the battery pack allowing it to lay flat against the first battery pack. It
should click into place (3);
-
The battery pack is now securely installed.
-
Place the bungee over batteries to hold them in place (4).
1
power
switch
3
Hugyfot
User Manual Vision Sony RX100 IV/V
2
2.1A
4

8. Installing the Sony RX100 IV/V camera

Prior to installing your Sony RX100 IV/V into your housing, set the mode selec-
tor to Program mode (M) (1).
-
Open the camera cradle door by pulling the lever as indicated below (2);
-
Fully open the camera cradle door (3);
-
Connect the USB-C and HDMI cables to your Sony RX100 camera (4);
-
Put your Sony RX100 IV/V camera into the camera cradle (5);
-
Close the camera cradle door by pushing cradle door locking levers as
indicated (6).
The housing is now ready to be closed (See step No. 6 - Table of Contents -
opening and closing your housing).
1
3
10
2
4

Advertisement

Table of Contents
loading

Table of Contents