Using the WPS function to connect devices
EN
WPS (Wi-Fi Protected Setup) allows you to connect new wireless devices with your
wireless network by pressing a button on the VMG5304. This allows you to quickly
and easily integrate devices that support the WPS function into your wireless
home network.
Press the WPS button on the VMG5304 for about one second. The WLAN LED
on the top of your device lights orange.
Enable the WPS feature on the wireless device within the next 2 minutes.
Observe the operating instructions of the corresponding device.
The Wi-Fi configuration has been successfully completed when the VMG5304
LED on the lights solid green again.
L
L
NOTE
You can change the setting for WPS via the user interface or even turn off WPS
completely if your VMG5304 is located at a freely accessible site, for example.
24 | ©2017