Sony 4-115-669-11(1) Operating Instructions Manual page 32

◆ MPEG (DVDs only)
Selects the type of MPEG audio signal.
PCM Select this when the player is
connected to an audio
component without a built-in
MPEG decoder. If you play
multi-channel MPEG audio
sound tracks, only the Front (L)
and Front (R) signals will be
output from your two front
speakers.
MPEG Select this when the player is
connected to an audio
component with a built-in
MPEG decoder.
◆ DTS
Selects whether or not to output DTS signals.
OFF Select this when the player is
connected to an audio
component without a built-in
DTS decoder.
ON Select this when the player is
connected to an audio
component with a built-in DTS
decoder.
• When you play a DVD VIDEO with DTS
sound tracks, set "DTS" to "ON" in
"AUDIO SETUP" (page 32).
• If you connect the player to audio
equipment without a DTS decoder, do not
set "DTS" to "ON" in "AUDIO SETUP"
(page 32). A loud noise may come out from
the speakers, affecting your ears or causing
the speakers to be damaged.
◆ 48kHz/96kHz PCM (DVD VIDEO only)
Selects the sampling frequency of the audio
signal.
48kHz/16bit The audio signals of DVD
VIDEOs are always converted
to 48kHz/16bit.
96kHz/24bit All types of signals including
96kHz/24bit are output in their
original format. However, if the
signal is encrypted for
copyright protection purposes,
the signal is only output as
48kHz/16bit.
32
b
The analogue audio signals from the LINE (RGB)-
TV jack are not affected by this setting and keep
their original sampling frequency level.