Sony 4-115-669-11(1) Operating Instructions Manual page 14

8
Press ENTER.
The Setup Display for selecting the type
of video signal output from the LINE
(RGB)-TV jack appears.
SCREEN SETUP
TV TYPE:
SCREEN SAVER:
BACKGROUND:
LINE:
9
Press X/x to select the type of
signal you want to output from the
LINE (RGB)-TV jack.
◆ Video signals
• VIDEO (page 29)
◆ RGB signals
• RGB (page 29)
10
Press ENTER.
The Setup Display for selecting the type
of jack used to connect your audio
component such as an amplifier
(receiver) appears.
Is this player connected to an amplifier
(receiver) ?
YES
NO
11
Press X/x to select the type of
jack (if any) you are using to
connect to an audio component,
then press ENTER.
If you did not connect an audio
component, select "NO," then go to step
15.
If you connected an audio component
using coaxial digital cable, select "YES:
DIGITAL OUTPUT."
14
JACKET PICTURE
VIDEO
VIDEO
DIGITAL OUTPUT
12
Press X/x to select the type of
Dolby Digital signal you wish to
send to your audio component.
If your audio component has a Dolby
Digital decoder, select "DOLBY
16:9
DIGITAL." Otherwise, select "D-PCM."
ON
RGB
13
Press ENTER.
"DTS" is selected.
14
Press X/x to select whether or
not you wish to send a DTS signal
to your audio component.
If your audio component has a DTS
decoder, select "ON." Otherwise, select
"OFF."
15
Press ENTER.
Quick Setup is finished and connections
are complete.
If your audio component has an MPEG
audio decoder, set "MPEG" to "MPEG"
(page 32).
AUDIO SETUP
AUDIO DRC:
DOWNMIX:
DOLBY SURROUND
DIGITAL OUT:
DOLBY DIGITAL: DOLBY DIGITAL
DOLBY DIGITAL
MPEG:
DTS:
48kHz/96kHz PCM:
AUDIO SETUP
AUDIO DRC:
DOWNMIX: DOLBY SURROUND
DIGITAL OUT:
DOLBY DIGITAL
DOLBY DIGITAL:
MPEG:
DTS:
48kHz/96kHz PCM:
STANDARD
ON
D-PCM
48kHz/16bit
STANDARD
ON
PCM
OFF
OFF
ON