Problem Solving - Russell Hobbs RHCC5001 Manual

PROBLEM SOLVING

PROBLEM
1. Not properly plugged into
outlet.
Cleaner Won't 2.
Run
3.
4.
Water keeps
leaking from the
brush bar.
The carpet feels
wet/water
logged.
The stain on the
carpet does not
appear to be
cleaned.
POSSIBLE CAUSE
No electricity in wall outlet
On/Off switch not turned on.
Blown fuse/tripped breaker.
1. None recommended cleaning
solution used.
2. Trigger partially blocked.
1. Too much cleaning solution
used in one area.
1. Pre-treatment is necessary
prior to using the carpet cleaner.
1. Plug in firmly.
2.
replace the fuse.
3. Push on/off switch to on.
4. Check fuse or breaker.
1. Use warm water 40 degrees
and flush the unit.
2. Use warm water 40 degrees
and flush the unit. Whilst
pressing and releasing the
trigger.
1. Use less cleaning solution over
the cleaning area. Run the carpet
cleaner over the area without
pressing the trigger to remove
excess water.
1. Use a pre-treatment cleaner
on the stained area and brush
away prior to using the carpet
cleaner.
14
SOLUTION
Reset circuit breaker or