Removing/Installing The Board; Bi-217/218/219 Board; Fm-96 Board - Sony XCD-SX90 Service Manual

1-3. Removing/Installing the Board

1-3-1. BI-217/218/219 Board

1. Remove the upper case and lower case.
(Refer to Section 1-2-1.)
2. Remove the front panel assembly.
(Refer to Section 1-2-3.)
3. Remove the two screws.
4. Remove the solders of CCD, then remove the BI-217/
218/219 board.
. BI-217 board: 16 solders
. BI-218 board: 24 solders
. BI-219 board: 20 solders
Front panel assembly
CCD
BI-217/218/219 board
Solders
This illustration is for XCD-V60/V60CR.
5. Install the BI-217/218/219 board in the order of steps
3, 4, 2 and 1.
XCD-U100/SX90/V60
XCD-U100CR/SX90CR/V60CR
PM2 x 4

1-3-2. FM-96 Board

n
When replacing the FM-96 board, perform the writing of
the serial number and Node Unique ID. For details, refer to
Section 2-1.
1. Remove the upper case and lower case.
(Refer to Section 1-2-1.)
2. Remove the rear panel assembly.
(Refer to Section 1-2-2.)
3. Remove the front panel assembly.
(Refer to Section 1-2-3.)
4. Disconnect the three flexible flat cables from the
connectors (CN200, CN400 and CN700) on the FM-96
board.
5. XCD-SX90/SX90CR:
Remove the three screws, then remove the shield sheet
and FM-96 board.
XCD-V60/V60CR/U100/U100CR:
Remove the three screws, then remove the FM-96
board.
PM2 x 4
XCD-SX90/SX90CR
Shield sheet
CN200
Flexible flat
cables
6. Install the FM-96 board in the reverse order of steps 1
to 5.
CN700
FM-96 board
CN400
Flexible flat cable
1-3