Round Type Connector (12-Pin); Matching Connectors And Cables; Signal Inputs And Outputs - Sony XCD-SX90 Service Manual

1-5. Round Type Connector (12-Pin)

1. Remove the upper case and lower case.
(Refer to Section 1-2-1.)
2. Remove the rear panel assembly.
(Refer to Section 1-2-2.)
3. Remove the CN-3020 board. (Refer to Section 1-3-5.)
4. Remove the nut and washer, then remove the round
type connector (12-pin).
Rear panel
Washer
Nut
5. Attach the round type connector (12-pin) in the reverse
order of steps 1 to 4.

1-6. Matching Connectors and Cables

When external cables are connected to the connector of
each unit, the hardware listed below (or equivalents) must
be used.
Connector Matching connector/cable
IEEE1394b IEEE1394b cable (9P-9P)
(Commercially available products)
IEEE1394b cable (9P-6P)
(Commercially available products)
DC IN Camera cable
CCXC12P02N (2 m)
CCXC12P02N (5 m)
CCXC12P02N (10 m)
CCXC12P02N (25 m)
XCD-U100/SX90/V60
XCD-U100CR/SX90CR/V60CR

1-7. Signal Inputs and Outputs

1 IEEE1394b connector 1 1
1 1
Round type
connector (12-pin )
Pin No.
1
2
3
4
5
6
7
8
9
2 DC IN: 12-pin (male) 2 2 2 2
Pin No.
1
2
3
4
5
6
1
. IEEE1394b-2002
9
1
— External view —
Signal name Remarks
TPB (_) Twisted pair B (_)
TPB (+) Twisted pair B (+)
TPA (_) Twisted pair A (_)
TPA (+) Twisted pair A (+)
TPA (R) Twisted pair A (Ground reference)
VG Power ground
N.C.
VP Power voltage input
TPB (R) Twisted pair B (Ground reference)
1 9
2 8
!/
3 !- !=
4 6
5
— External view —
Signal Pin No.
POWER_GND 7
POWER_IN 8
ISO_GND 9
STROBE_OUT 10
GPIO_OUT1_ 11
GPIO_OUT1+ 12
2
5
4
7
Signal
GPIO_IN2
GPIO_OUT2_
GPIO_OUT2+
GPIO_IN1
TRIGGER_IN
ISO_GND
1-7