Unattended Object Setting Tab; Time Setting; Detection Time - Sony SNC-RX530N User Manual

When the status lamp is gray, the camera is in the
process of acquiring a background image.
Unattended object detection does not work during
this period.
The status lamp turns green when the background
image has been acquired.
Note
When you acquire a background image, use an
image with as little motion as possible. If you use
an image with a lot of motion, it will take a long
time to complete acquiring of the background
image.
5
Check the Window 1 check box.
The Window 1 frame appears on the monitor
display.
6
Adjust the position and size of Window 1.
Drag Window 1 to move it and change its size.
7
Set the active or inactive windows.
Select Active to set Window 1 as an active area, or
Inactive to set it as an inactive area.
Note
If an active window and inactive window overlap,
the overlapped portion will be regarded as an
inactive area.
When the two windows overlap, the inactive
window is displayed over the active window on the
monitor screen. If the active window is hidden by
an inactive window and its position or size cannot
be changed, temporarily change the active window
to an inactive window and change the position and
size. After changing, reset it as an active window.
8
Set the function for Windows 2 to Windows 4.
Repeat steps 5 to 7 for each window.
9
Select the object size for Object size.
Select a larger size if a small noise may be detected
as an object by mistake.
10
Check whether an unattended object is detected
properly.
Place an object in the window and confirm that
unattended object detection works correctly.
The object regarded as an unattended object is
marked with a green frame.
Note
It may take a long time until an unattended object is
detected, depending on the image being shot.
11
Click OK.
82
Setting the Object Detection Function — Object detection Menu
The unattended object detection settings are
confirmed.
Note
Be sure to click the OK button to confirm the
settings. The setting will be cancelled if you do not
click the OK button.
12
When Preset position is selected for PTZ position,
perform settings for other preset positions.
Repeat steps 2 to 11 for each preset position.
13
Set Detection time, Alarm interval and Release
time in the Unattended object setting tab.

Unattended object setting Tab

Use this tab to set the alarm time for unattended object
detection.

Time setting

Unattended object detection requires the following three
kinds of time settings.

Detection time

Set the period of time from when an object appears in an
active window and stops or when an object in an active
window disappears until the point when that object is
regarded as an unattended object. An alarm will be
output if the specified period has elapsed.
You can set the time between 40 seconds and 12 hours.
Note
If Stay time for the tour function specified in the Preset
position menu (page 59) is shorter than Detection time,
the camera will move to the next preset position before
the object is regarded as an unattended object.