Table of Contents
Advertisement
Programming procedure of the Automatic mode
Programming the Automatic mode can be done in the Automatic mode or the
Manual mode.
1. Out of any adjustment mode, press down the
release it. It then enters into the programming of period 1 of the 5 days of the
week. The 5 days of the week (L/M, M/T, M/W, J/T, V/F), the period 1 (
the associated programming (hours and set point) are displayed. Note that the
time displays --:-- and the set point displays --.-- if there is no programming for the
period.
Note: if no programming is required for the period, simply press down the
then automatically switches to the next adjustment period.
2. The two hour digits of the period flash and can then be adjusted with the
buttons. Confirm the adjustment using the
3. The two minute digits of the period flash. Use the
intervals of 15 minutes. Confirm the adjustment by pressing down the
button.
4. The set point temperature of the period is flashing. Adjust the set point using the
and
buttons. Confirm your selection by pressing down the
5. The programming of this period is over. The programming of the next period is
displayed and you return to step 2.
6. At the end of the programming of the 4 periods of the week days, you enter into
the programming period 1 of the two days of the weekend. The two days of the
weekend (S/S, D/S), the period 1 and the associated programming (hours and set
point) are displayed. The programming of the weekend periods is made in the
same manner as for the periods of the week days (steps 2 to 5).
10
button during 3 seconds and
button.
and
buttons to adjust by
) and
button. It
and
button.
Hide quick links:
Advertisement
Table of Contents
