Weidmuller PMX420 Series Operating Instructions Manual page 9

InstrumentSetup(continued)
GeneralAlarmsettings*
Alarms 1 & 2
Select
Alarms 3 & 4
Select
Setpoint
security
Alarm reset
sequence
Note: alarm settings are only shown if the relevant alarm channel is enabled.
Alarmchannelonesettings*
Coil energisation
Alarm type
Setpoint value
Deadband value
Timer delay
Alarmchanneltwosettings*
As alarm channel one, except uses A2nE, A2nd, A2=L,A2=H, SP2=, db2= and dL2=.
Alarmchannelthreesettings*
As alarm channel one, except uses A3nE, A3nd, A3=L,A3=H, SP3=, db3= and dL3=.
Alarmchannelfoursettings*
Coil energisation
Alarm type
Note: for group or siren alarms, the setpoint, deadband and timer settings are skipped
Setpoint value
Deadband value
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
A12Y Enable
A12n
Disable (Select this option for PMX420)
A34Y
Enable
A34n
Disable (Select this option for PMX420)
SECy
Setpoints fixed at setup
SECn
Can change setpoints
nOr
Automatic reset
rES
Manual reset
A1nE
Normally energised
A1nd
Normally de-energised
A1=L
Low type (active below setpoint)
A1=H
High type (active above setpoint)
SP1=
Setpoint value
50. 0 0
e.g., 50.00 %
db1=
Deadband value
0. 0 1
e.g., 0.01 %
dL1=
Timer delay (set to 0 s to disable)
20
e.g., 20 s
A4nE
Normally energised
A4nd
Normally de-energised
A4=L Low type (active below setpoint)
A4=H
High type (active above setpoint)
A4=G
Group alarm
A4=S
Siren alarm (manual reset mode only)
SP1=
Setpoint value
50. 0 0
e.g., 50.00 %
db1=
Deadband value
10. 0 0
e.g., 10 %
Toggle Accept
Toggle Accept
Toggle Accept
Toggle Accept
Toggle Accept
Toggle Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept
Toggle Accept
Toggle Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept