Instrument Setup - Weidmuller PMX420 Series Operating Instructions Manual

• InstrumentSetup
For setup mode, connect the security link and press PGM and ENT keys
simultaneously. The software version will be displayed. If you wish to
continue, press ENT within 10 s.
Setting Display
S/W Version
DisplayandInputs
Display
Brightness
Input format
Damping factor
Linearisation
Display range
Analogueoutputs*
Analogue output
select
Analogue output
range
Note: if you change the output range you must calibrate the outputs.
Output action
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Description
S/W Version 1.01 (Note: this information only applies to versions
v1. 0 1
1.00 to 1.09)
LOBr
Low brightness
HIBr
High brightness
IP=1
Current (mA)
IP=E
Voltage (V)
IPL=
Input range lower limit
4. 0 0
e.g., 4.00 mA
IPH=
Input range upper limit
20. 0 0
e.g., 20.00 mA
dF=
Introduces the damping factor
2
Value, e.g., 2
LInr Linear
Sr
Square root
dP=
Decimal point position
.
dLO=
Display range lower limit
0. 0
e.g., 0.0
dHI=
Display range Upper limit
100. 0
e.g., 100.0
AOPY
Enabled
AOPN
Disabled (Select this option for PMX420)
OPL=
Output low value
4. 0 0
e.g., 4.00
OPH=
Output high value
20. 0 0
e.g., 20.00
OP=d
Direct
OP=r
Reversed
Å ì
ENT
Toggle Accept
Toggle Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept
Toggle Accept
- Next
Shift Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept
Toggle Accept
- - Next
Dec Inc Accept
- - Next
Dec Inc Accept
Toggle Accept