Table of Contents
Advertisement
9
Troubleshooting
Troubleshoot problems that occur by following the instructions in the table below.
No.
Problem
1
The LED does not light.
The color of the LED
2
differs from the desired
color.
3
The LED does not fl ash.
The sound of the buzzer
4
is low.
The buzzer does not
5
sound.
Check the "Information for Inquiries," and then contact the nearest PATLITE Sales Representative if you cannot resolve the
problem even after the above troubleshooting.
Product Name
IO-Link Signal Tower
(→
Model
Confi guration [p. 2])
Confi rmation
Has the wiring been connected properly?
Is the power source supplying the proper
voltage and current?
Is the processing data correct?
Is a custom independent color control unit
being used?
Is the processing data correct?
Are the parameters correct?
Are the volume settings for the buzzer too
low?
Is the processing data correct?
Is the Buzzer Unit attached?
Information for Inquiries
2
Model Number
Date of Purchase
Please provide as much detail
Problem
– 22 –
Remedy
Wire the LED again while referring to the
instructions in "
5
Wiring" (p. 6).
Check whether the connected IO-Link is
putting out the proper voltage.
Refer to the instructions in "
Use" (p. 7-8). and resend the
processing data.
Send processing data compatible with the
color selected in the control instead of the
light color for the independent color
control unit.
Refer to the instructions in "
Use" (p. 7-8). and resend the
processing data.
Specify the parameters while referring to
the instructions in "
6
How to Use"
(p. 7-8).
Adjust the volume while referring to the
instructions in "
7
Buzzer Settings"
(p. 9).
Send the process data while referring to
6
the instructions in "
How to Use"
(p. 7-8).
The Buzzer Unit is an optional part.
Check
"12
Optional Parts" (p. 27), and
then attach the Buzzer Unit to the product
by referring to "
8
Detaching the Unit"
(p. 10-21).
/
/
as possible.
6
How to
6
How to
Advertisement
Table of Contents
