VANATOO
TRANSPARENT ONE ENCORE
®
POWERED SPEAKERS
Quick Start Guide
1
Unpack Your System
1) Active speaker
2) Passive speaker
3) 2 Grills
4) IR remote control
5) Optional isolation feet
6) USB A to USB B cable
2
Connect the Speakers
The included speaker interconnect cable with screw-on collar
connectors makes this quick and easy.
3
Connect Power
Make sure the power switch (2) is in the OFF position.
1.
2.
Plug the AC power cord into the power outlet.
4
Connect Your Audio Source
Turn the volume controls on the speaker (1) and on the audio
source both to minimum.
1.
Analog (3) — Connect your source using the included
using 3.5mm to 3.5mm cable or 3.5mm to RCA cable as
appropriate for your source component.
2.
Digital Coax (4) — Connect your source component using
a 75 ohm digital coaxial RCA cable.
3.
Optical (5) — Connect your source component to the
Vanatoo T1E using a Toslink optical cable.
4.
USB (6) — Connect your computer to the T1E using the
supplied USB A to USB B cable. Select the Vanatoo T1E
in your computer's audio settings.
5.
Bluetooth —
a. Press and release the "Pair-Prog" button (7) on the
rear of the active speaker, or press "Enable" and
then "BT Pair" on the remote control.
b. Ensure Bluetooth is turned-on on your source
device and pair with the Vanatoo T1E.
c. Ensure your source device is connected to the
Vanatoo T1E over Bluetooth and play music!
™
7) 3.5 mm to 3.5 mm cable
8) Four conductor
speaker wire
9) 3.5 mm to RCA "Y" cable
10) Quick Start Guide and a
Safety Sheet
1
2
6
5
4
1
PAIR-PROG
3
7
8
9
3
8
9
7
SERVICE
™
2
4
5
6
TURN OVER