Advertisement
Preset Factory Codes
User Enter Code 2 3 4 5
(Note: To reset the access code remove 9 volt battery form unit, Depress any key
on the keypad and wait 10 seconds before installing battery.
Send a signal to channel 1 of TX module:
Send a signal to channel 2 of TX module:
Send a signal to channel 3 of TX module:
Send a signal to channel 3 of TX module:
Delete the Programmed User Entry Code
1. Enter the "Master Code" (default is
2. Press the
*
1
3. Enter 2 for delete a user code
0 1
4. Enter
for the number of user code (eg. "03" for the third user code, etc).
5. Press the
*
Multi-color Status LED
ORANGE - Key Depressed
RED - Entered Correct Code and Transmitting
GREEN - Programming Mode
GREEN FLASHING (3 times) - Error During Programming Mode
button
button.
2 3 4 5
(access code)
# 2 3 4 5 - 2
(access code)
# 2 3 4 5 - 3
(access code)
# 2 3 4 5 - 4
(access code)
1
2
3
4
)
Advertisement
