Welch Allyn Propaq LT Directions For Use Manual page 71

Directions for Use
Figure 74. NIBP: reading in progress
STEWART, ANN STEWART, ANN
NIBP in progress. NIBP in progress.
II II
HR/min HR/min
NIBP NIBP
NIBP Mode: NIBP Mode:
145 145
When the cycle completes, control returns to the previous direct-access display. To
view the final NIBP readings on the manometer scale, select Manometer from the
Setup NIBP menu.
Figure 75. NIBP: reading complete
STEWART, ANN STEWART, ANN
II II
PR/min PR/min
NIBP NIBP
NIBP Mode: NIBP Mode:
2 2
•
•
Note
8. If motion artifact such as shivering or coughing interferes with NIBP readings, do the
following:
•
•
•
7762940 7762940
Adult Adult Rm 263 Rm 263
1mV/cm 1mV/cm
NIBP mmHg NIBP mmHg Resp/min Resp/min
Manometer Manometer Systolic Systolic Diastolic Diastolic
Manual Manual
50 50 100 100 150 150 200 200
Exit Exit Trends Trends Snapshots Snapshots
7762940 7762940
Adult Adult
1mV/cm 1mV/cm
79 79 132/83 132/83
NIBP mmHg NIBP mmHg (98) (98) Resp/min Resp/min
Manometer Manometer Systolic Systolic Diastolic Diastolic
Manual Manual
50 50 100 100 150 150 200 200
Exit Exit Trends Trends Snapshots Snapshots
If you need to stop the reading and vent the cuff at any time during the
measurement, press
If the monitor cannot get a valid NIBP reading, it displays the message
'NIBP retry in progress' in the upper left corner of the screen. Then, depending on
settings and patient mode, the monitor attempts one or two more
measurements. If the retries fail to produce a valid reading, the monitor displays
an NIBP error message.
For every inch the cuff is placed above the heart, add 1.9 mmHg (0.253 kPa) to the
displayed NIBP reading. For every inch below the heart, subtract 1.9 mmHg
(0.253 kPa).
Position the patient's limb away from the body so that the applied cuff is not in
contact with the patient's body or any other object (such as a bed rail). Keep the
cuff as close to heart level as possible.
Verify that the Smartcuf filter is ON. (See
Smartcuf" on page 68.)
Verify that the ECG leads are properly connected to the patient, and monitor ECG
during NIBP. (ECG monitoring is required for Smartcuf.)
3:00:06P 3:00:06P
% %
SpO2 SpO2
Mean Mean
Manometer pressure indicator bar
250 250 300 300
Setup Setup
3:00:06P 3:00:06P
Rm 263 Rm 263
Systolic, diastolic, and MAP
(numeric)
% %
SpO2 SpO2
Mean Mean
Systolic, diastolic, and MAP
(graphical)
250 250 300 300
Setup Setup
.
"Improving NIBP accuracy with
Standalone monitoring 67