Meridian 112BST Operator's Manual page 25

IMPORTANT
The engine warranty is void if the engine is run
without oil.
3. Check the oil level in the engine's centrifugal
clutch reduction case.
4. Check hardware and fasteners; seed tender
frame to trailer tie-downs, hitch bolts, trailer
hitch to trailer bolts, and all other fasteners.
Tightentotheirspecifiedtorque.
5. Make sure the wheel bolt lug nuts are tight.
6. Check the tires and ensure that they are
inflatedtotheirspecifiedpressure.
7. Remove all entangled material.
8. Visually inspect the auger, auger tube, and
delivery spout for damage.
9. Test the Break-Away brake unit and the trailer
brakes.
a. Make sure the trailer brakes are operating
properly.
b. Make sure the trip wire to the break-away
switch is connected to the tow vehicle.
c. Make sure the pin is correctly installed in
the break-away switch.
d. Press the Test button. The indicator
should illuminate green. If the red light
illuminates, the battery charge is low.
Refer to the Break-Away System in the
Maintenance section for instructions on
charging the battery.
10. Check the tension of the auger drive belt.
Follow the instructions in the manual to correct
the tension and/or alignment.
25