Copying Images Using "Image Transfer - Sony DSC-U40 Operating Instructions (primary manual) Operating Instructions Manual

P
Disconnecting the USB
cable from your computer or
removing the "Memory Stick
Duo" from your camera during
a USB connection
For Windows 2000, Me, or XP users
1 Double-click
on the tasktray.
Double-click here
2 Click
(Sony DSC), then click [Stop].
3 Confirm the device on the confirmation
screen, then click [OK].
4 Click [OK]. Step 4 is unnecessary for
Windows XP users.
5 Disconnect the USB cable.
6 Remove the "Memory Stick Duo."
For Windows 98 or 98SE users
Confirm that the access indicators (page 57)
on the LCD screen are turned white and
carry out from step 5 above.
• If you remove or insert the "Memory
Stick Duo" before disconnecting the USB
cable, the computer will not recognize the
camera. In that case, disconnect the USB
cable and connect it to the computer
again.
58
Copying images using
"Image Transfer"
— Windows 98/98SE/2000/Me
Connect the camera and your
computer with the USB cable.
"Image Transfer" launches and the images
are automatically copied to the computer.
• Normally "Image Transfer" and "Date" folders
are created inside the "My Documents" folder,
and all of the image files recorded with the
camera are copied into these folders.
• You can change the "Image Transfer" settings
(page 59).
• When "ImageMixer" (page 56) is installed and
image copying is completed using "Image
Transfer," "ImageMixer" automatically
launches and images appear.
— Windows XP
Connect the camera and your
computer with the USB cable.
"Image Transfer" starts up automatically
and the images are automatically copied to
the computer.
Windows XP is set so that the OS AutoPlay
Wizard activates.
If you want to cancel the setting, follow the
procedure below.
a Click [Start], then click [My
Computer].
b Right-click [Sony
MemoryStick], then click
[Properties].
c Cancel the setting.
1 Click [AutoPlay].
2 Set [Content type] to [Pictures].
3 Check [Select an action to perform]
under [Actions], select [Take no
action], then click [Apply].
4 Set [Content type] to [Video files]
and repeat step 3. Then, set
[Content type] to [Mixed content]
and repeat step 3 again.
5 Click [OK].
The "Properties" screen closes.
The OS AutoPlay Wizard does not
start up automatically even if the
USB connection is made next time.