Table of Contents
Advertisement
Sonostat
3.1.2 Power regulator
The power regulator is located on the front panel and is used to adjust the ultrasonic
power.
It is activated by pressing the "Intensity" control panel shown
on the right. After activation, you can use the rotary encoder to
set the desired ultrasonic power.
After a timeout of 3 seconds, the knob becomes inactive and
must be released again before you may change the ultrasonic power.
3.1.3 The ultrasonic heads
The treatment heads can be connected to the right or left side of the device.
The treatment head has an LED lamp signaling the following states:
Importance
Head waiting for calibration
Head during calibrated
Head is calibrated and selected (= ready)
Head is calibrated and not selected
Head not coupled
Head is coupled
Error in head
Warning!
gbo Medizintechnik AG
Always handle all applicators with care. Do not let ultrasonic
heads fall down.
Remove gel residues directly after treatment completely from
the active metal surface of the ultrasound head.
Color
Type
orange
on
blue
flashing
blue
on
--
off
green
flashing
green
on
red
flashing
11
Version 1.2
Advertisement
Table of Contents
