Winter Storage / Spring Preparations; Measures Before Winter Storage - Ockelbo B21 CAB Owner's Manual

6.4 W
INTER STORAGE
Preparing boats for winter storage are subject to your location. In cold climates, always
have your boat hoisted in good time before the water freezes. This is an appropriate
time to perform all yearly maintenance, repair and inspection procedures. Even if your
boat is used around the year, a yearly maintenance period is recommended and shall
follow the same routines as specified below except when marked with a *.

6.4.1 Measures before winter storage

 Check the engine owner's manual and carefully follow the instructions.
 Lift your boat out from water well before ice formation. Your boat is not
dimensioned against sailing or storage in ice.
 Hoist the boat. Wash the bottom of the boat immediately afterwards. Algae and
slime easily comes if they are not let to dry.
 Remove the bottom drain plug (see chapter 7, figure 1 and position 22) and leave
the drain open.
 Check the condition of the hull. Repair damages directly or the next spring
before launching the boat.
 *When preparing to store a boat for extended periods, please refer chapter
6.1(Fuel System).
 Ensure that the hull has sufficient support to avoid damages or instability. If
uncertain, always consult experts such as your dealer.
 Follow the maintenance instructions given in the engine manual. We recommend
that you hire an authorized service company to ensure the safe and reliable
operation of the engine. Do not forget to service the engine controls and
steering system.
 Carryout maintenance operation on other accessories and equipment as
described in this chapter and in the respective OEM manuals
 If your boat is stored outside or in a humid place during the winter, remove
electronic instruments, the textiles, cushions, seats and other equipment that
may corrode or become mouldy in moist conditions, and store it in a dry place.
 Spray the electrical connectors with a suitable moisture repellent antioxidant.
 *Remove batteries and store them in a warm, dry place. Charge them at least
twice during the winter. Spray the electrical connectors with a suitable moisture
repellent antioxidant.
 Check conditions of anodes (see chapter 6.2.3). Replace if needed. Clean the
surface between anodes and hull to ensure good metallic contact. Never paint
them!
/
SPRING PREPARATIONS
6. MAINTENANCE__PAGE 56