Makita 4340CT Technical Information page 8

R
epair
3. Push rod into blade holder, and assemble retaining ring R-18 to the groove in blade holder as illustrated in Fig. 16.
4. Assemble dust cover as illustrated in Fig.17.
Retaining ring R-18
< 9 > Disassembling parts in gear housing
1. After taking off safety wire from gear housing cover, unscrew 4 pcs. of tapping screws CT 4 x 16.
Separate gear housing cover from gear housing. See Fig. 18.
4 pcs. of
Tapping screws CT 4 x 16
2. Locking crank complete with something bar-formed metal, unscrew 2 pcs. of hex socket head bolts M4 x 12 as
illustrated in Fig.19.
3. Disassemble retaining ring S-8. Then, the inner parts can be disassembled from gear housing as illustrated in Fig.20.
< Note in disassembling>
2 pcs. of hex socket head bolts M4 x 12 are adhesive bolts.
It is recommended to unscrew them with impact driver.
No.1R235
Round bar for arbor
Balance plate
Retaining ring S-8
Fig. 16
Safety wire
Retaining ring S-8
2 pcs. of hex socket
head bolts M4 x 12
Crank complete
Fig.19
Dust cover
Fig.17
Gear housing cover
Fig. 4
4340T, 4340CT, 4340FCT
Needle bearing 407
Crank complete
Balance plate
Gear complete
Push plate
Seal plate
Fig.20
Press dust cover to assemble
firmly to blade holder.
Fig. 18
Flat washer 8
Gear housing
P 8 / 16