Makita 4340CT Technical Information page 11

R
epair
< 12 > Disassembling lever 17 ( for orbital action mode change)
1. With referring to the following section, disassemble handle L and R, or head cover L and R, and gear housing cover.
"< 4 > Disassembling handle section" at page 3 (for 4340T, 4340CT, 4340FCT)
"< 5 > Disassembling gear housing cover section" at page 4
2. Disassemble stop ring E-5 from the shaft portion of lever 17 with small flat head screwdriver. See Fig. 35.
3. Aligning lever 17 with indication " III ", pull out it from gear housing. Then, cap 5 and compression spring 3
are disassembled. See Fig. 35.
Stop ring E-5
Align lever 17 with indication " III ".
Fig. 35
Cap 5
Compression
spring 3
Lever 17
P 11 / 16