Makita 4340CT Technical Information page 4

R
epair
2. After removing lead wires (black and white) from lead holder, separate handle L from motor housing.
Handle L
Lead wire
(black)
< 5 > Disassembling gear housing cover section
1.After taking off safety wire from gear housing cover, unscrew 4 pcs. of tapping screws CT 4 x 16.
Then, gear housing cover can be separated from gear housing. See Fig. 5.
2.Take off stop ring E-3 with small flat head screwdriver. And push slider to the lower dead point. See Fig. 6.
Slider
Pin 4
Rod
Brush holders
Fig. 4
4 pcs. of
Tapping screws CT 4 x 16
Safety wire
Stop ring E-3
Lead wire
(white)
Motor housing
Gear housing cover
4340T, 4340CT, 4340FCT
Fig. 5
Rod
Fig. 6
P 4 / 16
Slider in the lower
dead point