Makita 4340CT Technical Information page 6

R
epair
3. Align the hole of slider and the same of rod, and insert pin 4 into the aligned holes from left side as illustrated
in Fig. 9.
Stand slider and insert a pair of linear guide as illustrated in Fig. 9A.
4. Lifting up leaf spring, lay a pair of linear guide in order to position leaf spring on linear guides as illustrated
in Fig. 10.
And push slider to the center of linear guides. Fasten linear guides with 4 pcs. of pan head screws
M4 x 10 as illusdtrated in Fig. 10A.
Push slider to the
center of linear guides.
5. Assemble stop ring E-3 to pin 4 as illustrated in Fig. 11.
Check, whether slider can reciprocate on linear guide smoothly, or not.
If slider does not reciprocate smoothly, incorrectly assembled linear guides can interfere with slider
in reciprocating. Try again to assemble linear guides correctly.
Linear guide
Rod inserted into
gear housing cover
Slider
Fig. 9
Lay linear guides.
Lift up leaf spring.
Pan head screws M4x10
Slider
Pin 4
Rod
Slider, stood for setting
a pair of linear guide
Slider
Rod
Pin 4
(Insert it from left side.)
Linear guide
Fig. 10
Fig. 10A
Stop ring E-3
Fig. 11
P 6 / 16
Linear guides
Rod
Slider
Fig. 9A
Slider
Leaf spring