Mitsubishi SRK20ZSX-W Technical Manual page 123

- - - -
Hi - Me - Lo Hi - Lo Hi - Me
UH - Hi - Me UH - Me UH - Hi
" accordingly.
How to set function
1. Stop air-conditioner and press
buttons at the same time for over three seconds, and the
"FUNCTION SET " will be displayed.
2. Press (SET) button.
3.
Make sure which do you want to set, "
(remote control function) or "I/U FUNCTION
function).
4.
Press or button.
Selecct " FUNCTION " (remote control function) or "I/U
FUNCTION " (indoor unit function).
5. Press (SET) button.
6.
On the occasion of remote control function selection
"DATA LOADING" (Indication with blinking)
Display is changed to "01
Press or button.
"No. and function"are indicated by turns on the remote control
function table, then you can select from them.
(For example)
Function No.
Function
Press (SET) button.
The current setting of selected function is indicated.
(for example) "AUTO RUN ON"
selected
Press or button.
Select the setting.
Press (SET)
"SET COMPLETE" will be indicated, and the setting will be
completed.
Then after "No. and function" indication returns, Set as the
same procedure if you want to set continuously ,and if to
finish, go to 7.
7. Press ON/OFF button.
Setting is finished.
It is possible to finish by pressing ON/OFF button on the way, but unfinished change of setting is
unavailable.
During setting, if you press
Setting is memorized in the control and it is saved independently of power failure.
How to check the current setting
When you select from "No. and funcion" and press set button by the previous operation, the "Setting" displayed first is the current
setting.
(But, if you select "ALL UNIT ", the setting of the lowest number indoor unit is displayed.)
Operation message
Function description:
(SET) (MODE)
setting description:
FUNCTION "
" (indoor unit
1
Indoor unit selection button
On the occasion of indoor unit function selection
"DATA LOADING" (Blinking for 2 to 23 seconds to read the data)
". Indication is changed to "02 FAN SPEED SET".
Go to
[Note]
(1)
If plural indoor units are connected to a remote control, the
indication is "I/U 000" (blinking)
indoor unit connected is indicated.
(2) Press
If "02 AUTO RUN SET" is Select the number of the indoor unit you are to set
If you select "ALL UNIT
all unites.
(3)
Press
Setting
Press
"No. and function" are indicated by turns on the indoor unit function
table, then you can select from them.
(For example)
Press
The current setting of selected function is indicated.
(For example) "STANDARD"
selected.
Press
Select the setting.
Press
"SET COMPLETE" will be indicated, and the setting will be
completed.
Then after "No. and function" indication returns, set as the same
procedure if you want to set continuously , and if to finish, go to 7.
When plural indoor units are connected to a remote control, press
the AIR CON No. button, which allows you to go back to the
indoor unit selection screen. (example "I/U 000
(RESET) button, you return to the previous screen.
121
- -
PJA0 12D 730
,
Function No.
Fixing button
7
Finishing button
2
Starting button
Previous screen button
.
The lowest number of the
or button.
", you can set the same setting with
(SET) button.
or button.
Function No.
Function
(SET) button.
If "02 FAN SPEED SET" is
Setting
or button.
(SET) button.
")
'18 • SRK-T-234