Advertisement
Installation – Step 2
The TELSTRA GO SMART REPEATER - MOBILE only turns on when the Mobile Phone Network signals are at a
relatively low level, and in the ranges shown below:
3G (WCDMA850):
4G/4GX (LTE1800/LTE700):
Therefore it is not possible to properly observe the operation of the TELSTRA GO SMART REPEATER - MOBILE using
the Cel-Fi WAVE app, unless the installation is completed in a location where the Mobile Phone Network signals are
within the ranges above.
So Step 2 requires that the vehicle is moved to a location where the Mobile Phone Network signals are at a relatively
low level. If this is not done, then the antenna installation positions cannot be optimised or checked for adequate
performance.
Installation – Step 3
This is a critical step in the installation of the TELSTRA GO SMART REPEATER - MOBILE, and it must not be skipped
before moving on to Step 4 (permanent installation).
To ensure that the TELSTRA GO SMART REPEATER - MOBILE is working properly (ie. achieves either the best possible
performance possible, or at least sufficient performance to meet customer expectations), the TELSTRA GO SMART
REPEATER - MOBILE must be temporarily installed and the positions of the external and internal antennas must be
adjusted/optimised.
An example of a temporary installation is shown below. The external antenna is mounted outside the vehicle using
the magnetic mount base, the TELSTRA GO SMART REPEATER - MOBILE amplifier module is located somewhere
inside the vehicle (so that DC power can be reached). Exact antenna positions are not critical at this initial stage,
however the whole aim of this Step 3 is to conduct measurements to determine the best antenna locations for the
permanent installation.
Between -80dBm and -104dBm
Between -95dBm and -119dBm
Advertisement
