Advertisement
BOOST 0 – 3:
No to Poor performance improvement.
Therefore the most critical aspect of the TELSTRA GO SMART REPEATER - MOBILE installation is to determine the
optimal positions for mounting both the external and internal antennas, before the hardware is permanently
installed in the vehicle.
Installation – Step 4
Once the appropriate final antenna locations have been confirmed, then the final permanent installation can be
completed.
It is assumed that the permanent installation will be completed by a suitably qualified installer/technician, so the
specific requirements/details showing how to complete a permanent installation will not be outlined in this
document.
However, some of the key features of a permanent installation are listed below:
-
External antenna is mechanically fastened (eg bolted) to the vehicle external chassis, and weatherproofed.
-
External RF cables do not run across paintwork or across windows, etc.
-
External RF cables do not run through door/hatch/window weather seals.
-
External RF cables are not crushed by the closing of doors/hatches/windows.
-
Amplifier module is securely fixed to the vehicle using suitable mounting screws/bolts.
-
Amplifier module is located where it cannot be accidently struck by vehicle occupants (eg under a car seat,
inside car boot). Note that the amplifier module requires ventilation for cooling, so it should not be mounted
in enclosed vehicle cavities.
-
The amplifier module is located where it can be accessed (but not whilst driving), so that status LEDs can be
observed and the "Mode" button can be pressed.
-
All internal cabling (both power and RF cabling) is run behind vehicle trim to prevent inadvertent
contact/damage by vehicle occupants. Note that care must be taken to not interfere with the vehicle's safety
equipment such as airbags, seat belt tensioners, sensors, controls etc.
-
Power to the amplifier module is supplied by a direct connection to the vehicles electrical accessory circuit.
(Note that the unit should not be connected to a permanent vehicle power supply, otherwise there is a risk
of draining the battery).
It is expected that the qualified installer/technician will be responsible for ensuring the aspects listed above are
addressed during installation.
Telstra takes no responsibility for any adverse effects to the vehicle or its occupants if customers choose to install
the TELSTRA GO SMART REPEATER - MOBILE by themselves, or if the installation is not completed by a suitably
qualified technician/installer.
Advertisement
