Advertisement
WAVE App "SETTINGS" Screen
This screen offers the ability to control what frequencies TELSTRA GO SMART REPEATER - MOBILE will boost. This is
useful for optimising the unit for voice or internet, to maximise the internet speed or select a band that is
compatible with all phones in a vehicle.
The settings tab displays the following:
Booster Name – you can assign a name to your TELSTRA GO SMART REPEATER – MOBILE unit.
-
Software Version
-
Select by Technology – this allows selection of which technology is boosted (3G/4G/Auto). It is a software
-
control which is equivalent to the physical button on the TELSTRA GO SMART REPEATER - MOBILE amplifier
module. This control is useful if the TELSTRA GO SMART REPEATER - MOBILE amplifier module is mounted
under a seat and cannot be easily accessed.
Select by Band – this allows selection of which frequency is boosted. Band 3 = LTE1800 (4G), Band 5 =
-
WCDMA850 (3G), Band 28 = LTE700 (4GX)
NOTE: The TELSTRA GO SMART REPEATER - MOBILE will only amplify ONE band at a time. The band can be selected
manually using this screen, but if Auto is selected then the unit will automatically switch itself and choose one band
to amplify.
WAVE App "ADVANCED" Screen
The Advanced screen helps with setting up and optimising TELSTRA GO SMART REPEATER – MOBILE because this
screen reports system information, signal strength measurements, downlink system gain etc.
Some of the useful information that can be accessed include:
Donor RSSI – measurement of the incoming mobile signal
-
Downlink Centre Frequency – what frequency band is being amplified
-
External Antenna in Use – if the internal or external antenna is being utilised
-
Cell ID – ability to see nearby towers and their signal strength
-
Downlink System Gain
-
Examples of the Advanced screen are shown on the following page.
Advertisement
