Advertisement
Pre-Installation Assumptions
Since it is assumed that a suitably qualified installer/technician is completing the TELSTRA GO SMART REPEATER -
MOBILE installation, then practical details relating to the installation of electrical equipment inside a vehicle will not
be covered in this document.
It is also assumed that the correct RF assessment has already been made of the customer's situation, and that it has
already been determined that the TELSTRA GO SMART REPEATER - MOBILE is a suitable product to meet the
customer's expectations.
Finally it is assumed that the installer has already read and understood the Quick Start Guide, which explains the
basic set-up and operation of the TELSTRA GO SMART REPEATER - MOBILE unit. The Quick Start Guide also explains
the use of the Mode button and the meaning of the Status Indicator light.
TELSTRA GO SMART REPEATER - MOBILE Installation
This document will explain the specific installation requirements to ensure that the TELSTRA GO SMART REPEATER -
MOBILE is installed to achieve best possible RF performance.
The main steps for correct installation of the TELSTRA GO SMART REPEATER - MOBILE are outlined below:
1. Download and install the Cel-Fi WAVE App.
2. Move the vehicle to a location where Telstra's Mobile Phone Network signals are low (otherwise the
installation of the TELSTRA GO SMART REPEATER - MOBILE cannot be optimised).
3. Temporarily install the TELSTRA GO SMART REPEATER - MOBILE inside the vehicle using the magnetic mount
antennas, and adjust antenna positions to best performance (as shown by the Cel-Fi WAVE App).
Alternatively if the antenna positions are pre-determined and cannot be moved, then temporarily locate the
antennas in these locations and check that the TELSTRA GO SMART REPEATER - MOBILE performance is
sufficient (as shown by the Cel-Fi WAVE App).
4. After the appropriate antenna locations are confirmed, complete the final permanent installation.
Installation – Step 1
Go to the Cel-Fi website, and download the free WAVE App.
http://www.cel-fi.com.au/cel_fi_go_telstra_nextg_4gx_repeater_booster.html
Download the appropriate software via the link
For Computers:
Download and install the software/WAVE app. Connect a USB cable in between the Coverage Unit and your
computer. Note that a micro-USB port is located on the side of the TELSTRA GO SMART REPEATER - MOBILE amplifier
module (next to the power plug port).
For Smart Phones:
For smart phones, search for 'Cel-Fi WAVE' on the iPhone (iTunes) or Android store (Google Play), and install the free
WAVE app on your smart phone.
Bluetooth WAVE App for iPhone, Android & Computers
Advertisement
