Changing The Engine Oil - Toro Power Clear 721 R Operator's Manual

Changing the Engine Oil

Service Interval: After the first 2 hours
Yearly
If possible, run the engine for a few minutes before
changing the oil to warm it. Warm oil flows better and
carries more contaminants.
Engine Oil Specifications
Engine oil capacity
Oil viscosity
API service classification
1. Siphon the fuel from the fuel tank into an
approved fuel container, or run the engine until
it shuts off.
2. Move the machine to a level surface.
3. Place an oil-drain pan under the oil-drain plug,
remove the plug, and tip the machine backward
and drain the used oil in the pan
Figure 20
4. After draining the used oil, return the machine to
the operating position.
5. Install the oil-drain plug and tighten it securely.
6. Clean around the oil-fill cap
Figure 21
1. Oil-fill cap
7. Unscrew the oil-fill cap and remove it
21).
0.60 L (20 fl oz)
Refer to Figure 22.
SJ or higher
(Figure 20).
g006372
(Figure 21).
g006316
(Figure
8. With the machine in the operating position,
carefully pour oil into the oil-fill hole to the point
of overflow (Figure
Note:
You may tip the machine forward (handle
up) to make adding oil easier. Remember to
return the machine to the operating position
before checking the oil level.
Important:
Do not tip the machine all the
way forward onto its nose, or fuel may leak
out of the machine.
Use Figure 22
viscosity for the outdoor temperature range
expected.
9. Wait 3 minutes for the oil to settle and add
enough oil to bring it to the point of overflow.
10. Screw the oil-fill cap into the oil-fill hole, and
tighten it securely by hand.
11. Wipe up any spilled oil.
12. Dispose of the used oil properly at a local
recycling center.
14
23).
below to select the best oil
Figure 22
Figure 23
g011606
g006374