BRADEN PD12C Series Installation Maintenance And Service Manual page 31

Measure the distance from the motor mounting surface
to the inner brake race. With all components properly
installed, this distance should be 11/16 in. (17.5 mm) to
3/4 in. (19.1 mm). If this distance is less than 9/16 in.
(14.3 mm), the primary spacer may be positioned as
shown below and should be checked.
The Primary Thrust Plate is shown wedged between the
planet gears and the planet carrier. Note that the Pri-
mary Sun Gear and the entire Brake Clutch Assembly
have moved to the right (toward the hydraulic motor).
16. Engage the motor shaft with the brake clutch inner
race and lower motor into place. Tighten capscrews
to recommended torque.
17. Install the hoses that connect the manifold and
brake valve to the brake cylinder.
18. After the hoist assembly is complete, check all cap-
screws and fi ttings to make certain they have been
tightened correctly.
Refi ll the hoist with the recommended oil listed under
"Preventive Maintenance", and install the oil level plug.
31