BRADEN PD12C Series Installation Maintenance And Service Manual page 29

CAUTION
!
Be sure the vent plug is located above the horizontal
centerline for the intended application. Oil leakage
may occur if vent is positioned incorrectly.
4. Tighten the bearing support capscrews to the rec-
ommended torque.
5. Stand hoist on bearing support end. Install the out-
put sun gear and thrust washer into output planet
carrier.
6. Install the output planet carrier into the drum while
meshing the planet gears with the ring gear and the
planet housing with the bearing support.
7. Install the primary sun gear and thrust washer into
the primary planet carrier.
!
8. Install the primary planet carrier, meshing the planet
gears with the ring gear and the planet housing with
the output sun gear.
9. Install a new bearing in the drum closure as re-
quired. Use sealant on the outside surface of the
oil seal. Install with spring side of the seal toward
bearing, using a fl at plate to avoid distortion.
Install a new O-ring in the groove on the O.D. of the
drum closure.
10. Lubricate the O-ring and drum opening with petro-
leum jelly or gear oil and install the drum closure
into the drum.
29