Setup; Ac Power; Fuse Replacement; Fuse Replacement Diagram - Chauvet DJ Bubble King User Manual

3. S
ETUP

AC Power

Fuse Replacement

Fuse
Replacement
Diagram
Page 6 of 12
The Bubble King has a fixed voltage power supply and can work with an input voltage of
either 120 VAC, 60 Hz or 230 VAC, 50 Hz, depending on the specific model.
To determine the product's power requirements (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product's back panel, or
refer to the product's specifications chart. The listed current rating indicates the
product's average current draw under normal conditions.
Always connect the product to a protected circuit (circuit breaker or fuse). Make
sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
To eliminate unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by unplugging
it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the fuse holder out of the housing.
4. Remove the blown fuse from the holder.
5. Replace with a fuse of the exact same type and rating.
6. Insert the fuse holder back in place and reconnect power.
Disconnect the product from the power outlet before replacing the fuse.
Always replace a blown fuse with the same type and rating.
Spare fuse holder
(inside safety cap)
Installed fuse
(held by the plastic clip)
Safety cap
B-550 Bubble King User Manual Rev. 6