Table of Contents
Advertisement
Safety Instructions
1.
Read these safety instructions carefully.
2.
Retain this user manual for future reference.
3.
Disconnect this equipment from all AC outlets before cleaning. Use a damp
cloth to clean the equipment. Do not use liquid or spray detergents.
4.
For plugable equipment, the power outlet socket should be located near the
equipment and easily accessible.
5.
Protect this equipment from humidity.
6.
Place this equipment on a reliable surface during installation. Dropping or letting
it the equipment fall may cause damage.
7.
The openings on the enclosure are for air convection. Protect the equipment
from overheating. Do not cover the openings.
8.
Ensure the power source voltage is correct before connecting the equipment to
a power outlet.
9.
Position the power cord away from high traffic areas. Do not place anything over
the power cord.
10.
All cautions and warnings on the equipment should be noted.
11.
If the equipment is not used for a long time, disconnect it from the power source
to avoid damage by transient overvoltage.
12.
Never pour liquid into an opening. This may cause fire or electrical shock.
13.
Never open the equipment. For safety reasons, the equipment should be
opened only by qualified service personnel.
14.
If one of the following occurs, have the equipment checked by service person-
nel:
The power cord or plug is damaged.
Liquid has penetrated into the equipment.
The equipment has been exposed to moisture.
The equipment is malfunctioning, or does not operate according to the user
manual.
The equipment has been dropped and damaged.
The equipment shows obvious signs of breakage.
15.
Do not store the equipment in an environment where the temperature fluctuates
below -20 °C (-4 °F) or above 60 °C (140 °F). This may damage the equipment.
The equipment should be stored in a controlled environment.
16.
Batteries that are incorrectly replaced are at risk of exploding. Replace only with
the same or equivalent type recommended by the manufacturer. Discard used
batteries according to the manufacturer's instructions.
The sound pressure level at the operator's position, in keeping with IEC 704-1:1982,
does not exceed 70 dB (A).
DISCLAIMER: These instructions are provided according to IEC 704-1. Advantech
disclaims all responsibility for the accuracy of any statements contained herein.
Caution! For power adapter selection if a power adapter is not shipped with the
unit, information regarding the adapter output rating (12 Vdc, 5 A min, or
18 W min) is provided in the user manual.
v
IDS-3118W User Manual
Advertisement
Table of Contents
