Safety Valve - Stanley SXAC1521121 Manual

ADJUSTING THE PRESSURE
To adjust the outlet air pressure, use the red coloured
regulator knob and check the pressure on the outlet
pressure gauge, Pic. 8.
If the pressure needs to be lower, turn anti clockwise.
If the pressure needs to be higher, turn clockwise.
Use the gauge to ensure you set the correct
working pressure.
Note: Different air tools require different operating
pressures. Always check with the tool manufacturer
if unsure.

SAFETY VALVE

Pic. 9
NOTE: When checking the safety valve ALWAYS wear
safety glasses.
To check the operation of the safety valve the air tank will
need to be full. Gently pull the ring outwards. This should
release air under pressure. Release the ring and this should
stop the air out flow immediately.
If the safety valve does NOT work in this manner,
STOP the air compressor immediately and have the
air compressor checked / serviced by an authorised
service centre.
IMPORTANT
This compressor has a maximum pressure of 145PSI
(10 bar). Always regulate the outlet air pressure to
match your air tool.
Different air tools require different operating
pressures. Always check with the air tool
manufacturer if unsure.
PIC. 8
Regulator
Air Outlet
Tank pressure
gauge
Outlet
Pressure
Gauge
PIC. 9
14
Pull to check
operation