Advertisement

STCT224/250

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STCT224 and is the answer not in the manual?

Questions and answers

Summary of Contents for Stanley STCT224

  • Page 1 STCT224/250...
  • Page 2 FIG. A FIG. B FIG. C FIG. D ...
  • Page 3 FIG. E FIG. F FIG. G FIG. H   FIG. I FIG. J...
  • Page 4: General Safety Rules

    4 • ENGLISH IMPORTANT technical standards and legislation. The next period for This instruction manual provides important installation, use, testing will be determined by the responsible engineer maintenance and safety information and must be at hand at all himself. We recommend that the Pressure Vessel (tank) times.
  • Page 5: Technical Specifications

    ENGLISH • 5 The pressure vessel quality certificate must be presented to TECHNICAL SPECIFICATIONS authorities, in case of inspection. Keep it in a safe place along STCT224 STCT224 STCT250 STCT250 CT224 CT250 CT224 CT250 CT224 CT250 with the instruction manual.
  • Page 6: Operation

    6 • ENGLISH the hose nozzle. joints so that the charges, thermal expansion, piping’s 14. Oil Drain Plug.- Allows the removal of lubricant oil. weight, mechanical and thermal shocks or obstructions 15. Oil Gauge Dipstick.- Shows the oil level and allows its are not transmitted to the air receiver.
  • Page 7: Care And Maintenance

    120/127 2,0 Máx. ENGLISH • 7 6. Important: A compressor with good dimensions (with ► Repair and maintenance work other than described in this pressure switch) will have roughly six (6) starts per hour. section must only be carried out by qualified specialists. DIST.
  • Page 8: Service Information

    SPECIFICATIONS STCT224 STCT250 Air Flow Rate @ 40 PSI - 50Hz SCFM - L/min 3.7 - 105 3.7 - 105...
  • Page 9: Troubleshooting Guide

    ENGLISH 9 TROUBLESHOOTING GUIDE This section provides a list of the more frequently encountered malfunctions, their causes and corrective actions. The operator or maintenance personnel can perform some corrective actions, and others may require the assistance of a qualified StanleyBlack&Decker technician. Motor does not start or does not restart High temperature of the compressed air Problem...
  • Page 10 as indicated in Fig. B - Page 2 10 ENGLISH Too much dust and paint Clean the compressor externally. on the compressor. Water is mixed with the oil Change the lubricant oil and run (milky coloration). your pressure compressor for 15 min, at a maximum pressure of 100 psi (7.0 bar).

This manual is also suitable for:

Stct250

Table of Contents